Skip to the tester
PadTester

How to Fix Stick Drift

Start with the free fixes and only open the controller if they fail. Measure with the drift test before and after each step so you know what actually worked.

1. Confirm it really is drift

  1. Run the drift test three times with the controller lying flat. Note the worst offset and direction.
  2. Press Save as “before” so you can compare later.
  3. If the offset is under 10 %, your controller is within the normal range. A game with a very small deadzone may be the cause; raise its deadzone first.
  4. Test on another device or browser if you can. If the drift disappears there, the problem is software settings, not the stick.

2. Free fixes: deadzone, calibration, firmware

PlatformStick calibrationOther fixes
Nintendo SwitchSystem Settings → Controllers and Sensors → Calibrate Control SticksUpdate the controller from the same menu
PlayStation 5None built inUpdate controller firmware on the console or with Sony's PC updater; raise in-game deadzones
Xbox / WindowsNone for Xbox controllersUpdate firmware in the Xbox Accessories app; raise in-game deadzones
Windows, other controllersGame Controllers panel → Properties → CalibrateSteam Input lets you set deadzones per controller
Steam (any)Steam Input → controller settingsInner deadzone per stick, works in every Steam game

Set the game's deadzone to the suggested deadzone from the drift test. That hides the drift completely without making aiming feel slow.

3. Clean the stick (without opening it)

  1. Turn the controller off and unplug it.
  2. Push the stick to one side and blow short bursts of compressed air into the gap at its base. Rotate and repeat all around. Hold the can upright so no liquid comes out.
  3. If that's not enough, put a few drops of isopropyl alcohol (90 % or stronger) on a cotton swab, not directly into the controller, and wipe around the base while moving the stick in circles.
  4. Let it dry for at least 15 minutes before switching it on.
  5. Run the drift test again and compare with your saved result.

Never use water, oil-based sprays or contact cleaners that leave a residue; they attract more dust.

4. Warranty and repair

  • Under warranty? Contact the manufacturer before opening anything. Opening the shell usually voids the warranty.
  • Replacing the stick module is a soldering job. Repair shops do it quickly; kits exist for confident DIYers.
  • Hall effect or TMR replacement sticks use magnetic sensors instead of wearing contacts. They're the longest-lasting fix where a compatible module exists.
  • If the drift keeps coming back within weeks, the module is worn; cleaning only buys time.

5. Check the result

After each step, run the drift test again. A fix worked if the worst offset drops and stays down after a few days of play. Check the edges too with the circularity test: a stick that was cleaned should still reach the full ring.

Frequently asked questions

Does calibration fix drift permanently?

Calibration resets the centre point, which fixes offsets from small changes. It can't fix a worn sensor; if the drift returns, the stick is wearing out.

Is stick drift covered by warranty?

Usually yes, within the warranty period, as long as the controller hasn't been opened. Check the manufacturer's support pages for your region.

Can I fix drift without opening the controller?

Often. Deadzone settings, calibration and cleaning from the outside solve many cases. Opening it is only needed to replace the stick.

Will a new controller drift too?

Standard sticks wear with use, so drift can appear after months or years. Controllers with Hall effect or TMR sticks are much less prone to it.

More tests

Updated: 2026-11-21