What circularity tells you
A stick should reach the same distance from the centre in every direction. The drawing shows the furthest point the stick reached in each 5° slice. The dashed circle is the ideal.
The average error is how far, on average, the real edge is from that circle. A low number means walking diagonally feels as fast as walking straight, and aiming is even in every direction.
How to run it
- Open the Circularity tab and press Reset.
- Push one stick all the way out and rotate it slowly, two or three full turns, keeping it pressed against the edge.
- Repeat with the other stick. Wait until Covered reaches 95 % or more before reading the result.
How to read the average error
| Average error | Meaning |
|---|---|
| Under 8 % | Round and even. Healthy. |
| 8–15 % | Slightly uneven. Common and usually unnoticeable in games. |
| Over 15 % | Very uneven, or the controller reports a square range on purpose (see below). |
Why some controllers draw a square
Some controllers report their stick range as a square instead of a circle: at the diagonals both axes reach 100 % at once. That's a design choice, not damage, and it gives a high error here. If both sticks draw the same neat square, it's by design.
Worry when the shape is lopsided: flat on one side, a dent in one direction, or very different between the two sticks. That points to wear, dirt or a damaged stick module.
Fixing uneven range
- On a Switch, use the console's stick calibration in System Settings. On Windows, older DirectInput controllers can be calibrated in the Game Controllers panel.
- In Steam, Steam Input lets you set an outer deadzone per controller, which rounds off a stick that never quite reaches the edge.
- Dirt around the stick base can limit travel in one direction. The cleaning steps in our drift fix guide help here too.
Frequently asked questions
My error is high but games feel fine. Is something wrong?
Probably not. Games remap the stick range and most apply an outer deadzone. If the shape is symmetrical and the same on both sticks, it's how the controller reports its range.
Should I test circularity before or after the drift test?
Either order works. Drift is about the centre, circularity is about the edge. A worn stick often fails both, which is a good sign that it needs replacing.
Why does the coverage stop at 90 %?
You haven't pushed the stick fully out in some directions, or it can't get there. Rotate slower and press firmly against the edge. If one slice never fills, that direction may be blocked.
More tests
Updated: 2026-11-21